Butyl Tape Waterproof Adhesive Tape Aluminum 4" W X 16'L Self Adhesive Thick Rep

Description: ☆Leak-Trapping Tape is a new generation of waterproof membranes made of high quality double-sided thickened butyl rubber and an aluminum surface with metal mesh.Its veneer has the texture of metal aluminum foil,the thickness of the individual layer is increased more than several times.The aluminum foil uses polymer synthesis technology,and the product is more wear-resistant, resistant to high temperatures and aging.The aging process is more than a multiple of the life of a normal aluminum foil. ☆It is suitable for roof, glass, painted steel and other gap sealing, pipeline corrosion, DIY sealing, tiles, pond foils, PVC, EPDM, etc. ☆Advantage: It has strong initial adhesion and requires two people to pull it apart with bare hands. Wear-resistant and tensile resistant, good initial adhesion, strong load-bearing capacity, stone slabs can be worn. ☆Our adhesive tape can be applied easily, quickly and ideally to narrow corners, textured, uneven and jagged surfaces. You can also easily use it for unusual patterns. ☆Note 1.Before gluing, the surface must be kept clean and dry without obvious dust particles present 2.The longer the time, the stronger the stickiness. Do not tear them after inserting 3. Do not touch water for 24-hours after gluing Product Description WATERPROOF BUTYL TAPE Leak-Trapping Tape is a new generation waterproof membranes,which are made of high quality double-sided thickened butyl rubber and an aluminum surface with metal mesh. The aluminum foil uses polymer synthesis technology and the product is more wear-resistant,resistant to high temperature and aging. The aging process is more than a multiple of the life of a normal aluminum foil. Advantage: It has strong initial adhesion and requires two people to pull it apart with bare hands. Wear-resistant and tensile resistant,good initial adhesion,strong load-bearing capacity, stone slabs can be worn. The elongation rate is high. The thickened square metal aluminum material is more wear-resistant than ordinary aluminum foils and has a longer service life. Specification: Material:aluminium foil /butyl rubber Impermeable:Yes Working Temperature: -40 ℉ to 248 ℉ Tensile strength:strong Breaking elongation:high Size: 4inch(B)*0.047inch(D)*16ft(L) Applicable scenarios Steps to use The adhesive areas should be clean and dry.Remove moss and excess sand from the roofing board beforehand. Cut off the desired size and tear off the lower film of the tape.Scissors or knives are glued with bitumen after a few centimeters. Attached to the surface of the gap Press firmly,press it down and remember to squeeze out the bubbles.It is best to wear disposable gloves at work. Attention: If it is cold, you can warm up the tape beforehand on the heater and press it warm on the roof with a hot air

Price: 21.78 USD

Location: Denver, Colorado

End Time: 2024-10-30T20:52:06.000Z

Shipping Cost: 0 USD